Kataloge >
APEM GmbH >
1000HE series

1000HE series
1 / 4Seiten

Katalogauszüge

1000HE series Compact & rugged fingertip controllers • switching technology DISTINCTIVE FEATURES One or two axis V4 Micro Switches up to 10 A Single or double pole 22 mm bush mounting Sealed up to IP67 ENVIRONMENTAL SPECIFICATIONS • Operating Temperature: -20 °C to +50 °C (-4 °F to +122 °F) • Sealing: IP67 with rubber boot (dependant on configuration) ELECTRICAL SPECIFICATIONS • Maximum Voltage Range: 30 VDC • Nominal Current: 4 A - 10 A • Number of Switches: 2, 4 or 8 • Contacts: 4 A • 30 VDC - V4 Gold 10 A - V4 • 30 VDC Silver Right-angle - V4 silver 4 A • 30 VDC Fast on style - V4 silver 4 A • 30 VDC • Switch Contact: Changeover • Contact Life: Load Dependent MECHANICAL SPECIFICATIONS • Mechanical Angle of Movement: 24° (12° from center) • Mechanical Life: 1 million lifecycles (dependant on configuration) • Mass/weight: 70 g (2.47 oz) MATERIALS • Shaft: Stainless steel • Boot: Neoprene • Housing: Mineral filled nylon-6 • Handles: BE Aluminum & phenolic; BH Aluminum The company reserves the right

Katalog auf Seite 1 öffnen

1000HE series Compact & rugged fingertip controllers • switching technology MOUNTING PANEL CUT-OUT Apply the assembly base through the mounting cut-out. NOTE: The joystick is mounted from beneath the panel. INSTALLATION - BE HANDLE Machined HEX finishing NUT Apply torque of 1-1.5 Nm to seal. Ensure that the rubber O-ring is in position before threading the top section on. Existing 1000 series 22mm (0.87in) bushing and panel cut-out. Kumho Sealing Boot Nitrile Rubber O-Ring Apply the assembled base through the mounting cut-out in the panel (shown above left)

Katalog auf Seite 2 öffnen

Compact & rugged fingertip controllers • switching technology MOUNTING (CONTINUED) INSTALLATION - BH HANDLE Machined HEX finishing NUT Apply torque of 1-1.5 Nm to seal. Ensure that the rubber O-ring is in position before threading the top section on. Kumho Sealing Boot Oil, Petroleum & UV resistant Existing 1000 series 22mm bushing and panel cut-out. Nitrile Rubber O-Ring Apply the assembled base through the mounting cut out in the panel (shown above left)

Katalog auf Seite 3 öffnen

Compact & rugged fingertip controllers • switching technology BUILD YOUR PART NUMBER Single pole Double pole - Limiter Fitted External Boot Identifier (8) NOTE: Double pole version is 27.5 mm (1.08 in) deep below panel NOTE: Users may still select their choice of V4 Micro switch and number of poles according to the standard 1000 series option list. Users may also select the joystick to have an open square gat (when no limiter is fitted) or a metal slot or cross limiter factory fitted. 4 External Boot Identifier (8)

Katalog auf Seite 4 öffnen