Multiheat Warmwater heater Installation Manual
8Seiten

Showroom: Postal address: Phone: E-mail: Web: Den Akker 10 – 3862 RB Nijkerk – The Netherlands Transportweg 50 – 3371 MB Hardinxveld-Giessendam – The Netherlands (+31) 342-712033 – Fax (+31) 842-104525 info@multiheat-international.com www.multiheat-international.com INSTALLATION MANUAL MULTIHEAT HEATER 50 /

Air distribution unit Wire mesh guard Main body Fan supporting block with screw Fan Heat exchanger Bolt (M6x16) with nut & ring Bolt (M8x25) with nut & ring Bolt (M6x40) with nut & ring Bolt (M10x20) with nut & ring to connect wire mesh guard (2) with air distribution unit (1) to connect main body (3) with air distribution unit (1) and fan supporting block (4) to connect fan arm with fan supporting block (4) to connect heat exchanger (6) with main body (3)

Assembling the Multiheat heater Step 1 Connect wire mesh guard (2) with air distribution unit (1) by using A1 + A2 bolts (M6x16) with nuts & rings. Step 2 Connect air distribution unit (1) with main body (3) by using B1 + B2 bolts (M8x25) (3x) with nuts & rings. Place the B1 bolt (M8x25) through the fan supporting block (4) and main body (3) and air distribution unit (1) and tighten the bolt with a nut and ring on the outside. Step 3 Place the fan arms into the fan supporting block (4) (already connected to the main body (3)) by using C1 + C2 bolts (M6x40) and nuts. Step 4 Connect the main...

Installation kit (option; not included as a standard); consisting of: 4 x Screwhook for heavy duty pulley 4 x Heavy duty pulley 30 m. Galvanised steel cable 4 x Cable tensioner 8 x Cable clamp 1 x Main pulley w/wall bracket I-1 1 x Hand winch w/wall bracket Extra options for installation (not included as a standard): F 2 x Ballcock valve 1" (Multi 50) or 5/4" (Multi 60 / 70) J 2 x Water hose 1" (Multi 50) or 5/4" (Multi 60 / 70)

Installation of Multiheat heater (continued)

Pipe diameters (see below) are an indication, pipe size is calculated with a water capacity/flow rate reaching a room temperature of 35°C and a water temperature of 90°C (see heater capacities on the last page).

Cleaning the Multiheat heater and chimney (option; not included as a standard) Heat exchanger Main body & air distribution unit Fan : clean with low pressure water : clean with high pressure : cover in plastic to prevent from water; clean fan with a brush only ! Chimney (option) : clean with high or low pressure

Showroom: Postal address: Phone: E-mail: Web: Den Akker 10 - 3862 RB Nijkerk-The Netherlands Transportweg 50 - 3371 MB Hardinxveld-Giessendam -The Netherlands (+31) 342-712033 - Fax (+31) 842-104525 i nfo@multi heat-i nternational.com www.multiheat-international.com