HAY PROCESSOR PF600
1 / 3Pagine

PF 600 Hay processor – for either round – square – dry or humid bales Cuts round and square bales into short prickly fiber 1-1/2 to 3 in. long (38 - 76 mm)* Prickly fiber stimulates enzyme activity in the rumen, promotes cow’s health and helps increasing the value of the milk components 4 seasons design! Can be installed indoors or outdoors *Results may vary according to forage quality (moisture, length of fiber, density). Some features are optional. Features, specifications and dimensions may vary without notice. Existing machines can be different. Safety guards are removed for viewing. Never operate a machine with missing safety guards. For installation, start up and operation, see the operator’s manual supplied with the machine. Cutting system : High rotor velocity 38 in. (965 mm) in length with standard 42 knives or 84 knives optional   Sharp cut, prickly fiber Wide cutting surface and fast processing time Uniform, consistent cut throughout the bale Fewer knives than most competitors’ Easy replacement bolt-on knives No sharpening Fast knife replacement Low cost wear parts Pneumatic suspension rotor Reduced load at start up Low energy consumption Efficient use of available power Enables single or dual-motor drive Variable tub speed a

High capacity tub – Inside Diameter : 71 in. (1803 mm) Handles round and square bales Holds 1 round bale or 1 large square bale Loading hopper Enables easy loading of large square bales, complete or sliced (rotocut) Holds 2 round bales or 1 large square bale Compatible with most bale handling devices: large bale conveyor, fork attachment, grapple, bale grabber, stabber Limit switch to stop tub rotation Adjustable time delay that enables stopping the front doors in the wanted loading zone Rovibec designed Compatible with bales of all sizes and dimensions Only 1 machine required to cut a...

High output Links directly to any TMR mixer Series MX Pneumatic control with pressure gauge Accurate setting of rotor pressure allows maximum motor efficiency Electromechanical control panel Stand-alone control panel, fully compatible with control panels of automated systems Long-lasting components Electrical: 200 - 600 VAC Power: 20 - 30 hp (15 - 22 kW) The PF600 is suitable for indoor or outdoor installation. Area required for installation = 12 X 12 ft. 3658 X 3658 mm Vertical clearance = HEIGHT + 48 in.