カタログ >
APEM GmbH >
QH series

QH series
1 / 8ページ

カタログの抜粋

QH series Halo LED illumination DISTINCTIVE FEATURES Single, dual and RGB colors available Designed to integrate with Ø16, Ø19, Ø22 and Ø30 mm panel cutout switches and other APEM and IDEC components Ø22 mm oversized version for integration with APEM’s range of Emergency Stop switches Panel sealed up to IP67 200 mm 26 AWG UL1061 wire terminations ENVIRONMENTAL SPECIFICATIONS • Panel Seal : IP67 to EN60529 : 1992 • EMC Immunity : EN61000-4-3, 100V/m, extended to radiated fields in frequency range of 80MHz-2.7GHz, 1kHz 80% sine wave modulation • EMC Emissions : EN61000-6-4 : 2011, Class B 30Mhz-11Ghz • Electrostatic Discharge : EN61000-4-2 up to +/- 15 KV • Operating Temperature Range : -30 °C to +70 °C (-22 °F to +158 °F) GENERAL SPECIFICATIONS • Max Reverse Voltage : 5 VDC • Life Expectancy : 50,000 Hours • Single color PCB : 12 LED’s • Dual color PCB : 12 LED’s, 6 of each (alternately placed) • RGB color PCB : 12 LED’s MATERIALS • Body : PC • Lens : PC The company reserves the right to change specifications without notice. LED characteristics are dependent upon environmental conditions. Therefore published data should be considered

カタログの1ページ目を開く

QH series Halo LED illumination ELECTRICAL SPECIFICATIONS Voltage Operating Voltage Operating Current * Customer to supply resistor for desired operating current. STANDARD LED INTENSITY LED COMPONENT SPECIFICATIONS Intensity Forward Voltage (typical) RGB LED INTENSITY LED COMPONENT SPECIFICATIONS Intensity Forward Voltage (typical) • The operating voltage must not be exceeded by more that 10% as this will result in reduced life expectancy • Luminous intensity is measured at 20 mA on a discrete led unless otherwise stated. • Luminous intensities and color shades of white LEDs may vary within...

カタログの2ページ目を開く

CIRCUIT DIAGRAM Colour 1 +12-24Vdc R5 (Add For single 0R Colour Operation) Colour 2 +12-24Vdc

カタログの3ページ目を開く

CIRCUIT DIAGRAM (CONTINUED)

カタログの4ページ目を開く

BUILD YOUR PART NUMBER BEZEL COLOR LENS COLOR Frosted White QH22L57YC Shown fitted to an Emergency Stop switch ABOUT THIS SERIES • Standard wire length is 200 mm, 26 AWG UL1061, for other wire lengths please contact APEM • Colored wire denotes Anode (+), black wire denotes Cathode (-) • Supply voltage is 12 to 24 VDC, for alternative voltages please contact APEM • Dual color LEDs are alternately placed on the internal PCB, by connecting one colored wire (+) a color is produced, by connecting the other colored wire (+) the second color is produced • When implementing full-spectrum RGB the...

カタログの5ページ目を開く

QH series Halo LED illumination QH16 - 16 MM (.634")

カタログの6ページ目を開く

Halo LED illumination BUILD YOUR PART NUMBER BEZEL COLOR LENS COLOR PROTECTION GUARD QH3028RC-X0875 Note: QH30 only available with protection guard ABOUT THIS SERIES • Standard wire length is 200 mm, 26 AWG UL1061, for other wire lengths please contact APEM • Colored wire denotes Anode (+), black wire denotes Cathode (-) • Supply voltage is 12 to 24 VDC, for alternative voltages please contact APEM 7

カタログの7ページ目を開く