415
1 / 2ページ

カタログの抜粋

Mechanical control lever Lever 415 is for machines which, running most of their time at a fixed speed, they can fulfil the new regulations on low emissions without the need to equip the motor with an expensive Electronic Control Unit (ECU). Typical application’s examples are machines with EPA homologation Lever 415 offers the possibility to set minimum and working speeds, clearly identified with detents. Intermediate working speeds are not allowed because a return spring pushes back to minimum the lever and consequently the engine speed goes back to minimum, as soon as the lever exits from the working position. t se dju s 77 the tabl ° ma e an x r gle pm to The turn-off of the motor is actuated by pushing the lever beyond neutral position. For all the other functions this lever is similar to lever 410 previously described. Anti-tampering screw VERSIONS & CODES Version Outgoing cable position FLEXBALL I T A L I A N A WR CONTROLS GROUP Each engine is optimized at its working speed where CO2 emissions are reduced below permitted levels. Once the working position has been defined during commissioning, the anti-tampering screw fixes permanently the working motor speed. Idle positio

カタログの1ページ目を開く

CABLES FOR LEVERS SERIES 410 AND 415 ø2x49 ø2x49 ø2x49 wires wires wires ø2x49 ø2x49 ø2x49 wires wires wires “A” specifies cable lever side thread “F” specifies cable engine side thread “mmmmm” is the length of the cable in mm Flexball Italiana S.r.l. Via San Luigi 13/A - 10043 Orbassano (To) - Italy Tel 0039.011 90.38.900 - Fax 0039.011 90.38.747 info@flexballitaliana.com www.flexballitaliana.com Cables are shown at mid stroke position FLEXBALL I T A L I A N A WR CONTROLS GROUP

カタログの2ページ目を開く

415 1 / 2ページ

カタログの抜粋

Flexball Italianaのすべてのカタログと技術パンフレット

415
1 / 2ページ