Catalog excerpts
Turning-counting dials potentiometer MB Standard dimensions Model MB10-25B ø26 ± 1 Model MB10-30B Note: The dimensions of mark are determined by the potentiometer to be mounted. General Specifications Matching Shaft Dia. (mm) Model No Standard Combinable Helicalohm Pot. (Matching shaft length of 25mm) Lock Device Operating Temperature Range Special Specifications Available Special colors on housing and spin plate on top of the knob (black, etc)
Open the catalog to page 1ALTHEN SENSORS & CONTROLS Note: The nut with a mark is not always used depending on the kind of potentiometer and the thickness of the panel to be mounted. In case of mounting Model MB Series counting dials on Helicalohm pot ., the mounting adaptor of these counting dials and Helicalohm potentiometers are fixed on the panel according to the illustration given above. The shaft of the Helicalohm Pot. is turned anticlockwise to its limit and is put into the mounting hole of the dial which was already set at "0". The shaft of the Helicalohm pot. is secured by the screw positioned on the knob of...
Open the catalog to page 2All Althen Sensors and Controls catalogs and technical brochures
-
HED Series Finger joystick
4 Pages
-
MFD Series Finger Joystick
4 Pages
-
C90JAMC90JBM
3 Pages
-
MA
1 Pages
-
DA10-24B
3 Pages
-
OF46HD-10
2 Pages
-
OFCP50
1 Pages
-
OF50
1 Pages
-
OF30
1 Pages
-
46HD
3 Pages
-
22HP
2 Pages
-
20HP
2 Pages
-
10HP
2 Pages
-
12HP
2 Pages
-
Model 200FCW
2 Pages
-
HE3 Series
11 Pages
-
HE2 Series
9 Pages
-
HE1 Series
10 Pages
-
TS2 Series
3 Pages
-
TS1 Series
5 Pages