Wirewound (Bushingmount) ALTHEN SENSORS & CONTROLS OF30■ Standard dimensions Model OF30 Note: 1 pc. each inner teeth washer and hex nut are attached ■ General Specifications Standard Resistance Range: Max. Practical Resistance Value: Total Resistance Tolerance: Independent Linearity Tolerance: Power Rating: Noise: 500Q to 10kQ 20kQ Standard Class ±10% (K) Precision Class ±5% (J) Standard Class ±2.0% Precision Class ±0.5% 0.75W Within 100Q E.N.R. Electrical Travel: Mechanical Travel: Insulation Resistance: Dielectric Strength: Starting Torque: Resist. Temperature Coefficient of Wire: Mass: ■ Standard Resistance Values | No. Of Wire Turns | Resistance Wire Used Resist. wire used Ni-Cr System Note: Mark ^ shows value at special higher practical resistance ■ Special Specifications Available Lower resistance values (50Q to 200Q), extra taps (available up to 1 tap), special electrical travel, shaft dia. (0 3.175mm) • bushing with inch dimensions, special machining on the shaft, with stopper (rotating angel becomes 300° and stopper strength is 0.3N-m [3kgBcm]). The information provided herein is to the best of our knowledge true and accurate, it is provided for guidance only. All specifications are subject to change without prior notification. Althen - Your expert partner in Sensors & Controls | althensensors.com Althen stands for pioneering measurement and custom sensor solutions. In addition we offer services such as calibration, design & engineering, training and renting of measurement equipm ent. Germany/Austria/Switzerland Benelux France Sweden USA/Canada Other countries [email protected] [email protected] [email protected] [email protected] [email protected] [email protected]