Catalogs >
APEM GmbH >
Q14 series

Q14 series
7Pages

Catalog excerpts

Ø14 mm panel mount LED indicators DISTINCTIVE FEATURES 10 mm colored diffused epoxy lens or 10 mm water clear super bright LEDs Prominent and flush bezel styles (2.8 x 0.8) solder lug/faston terminals, pins or (200 mm long) wire terminations Custom engraving available Available in RGB ENVIRONMENTAL SPECIFICATIONS • IP67 sealing option (EN60529) • Operating & Storage Temperature Range: Rear plastic body: -30 °C to +65° C ( -22 °F to +149 °F) Rear epoxy body: -40 °C to +85° C ( -40 °F to +185 °F) GENERAL SPECIFICATIONS • Max Reverse Voltage: 5 V • Viewing Angle: 30–100° (dependant on model) • Life Expectancy: 100,000 hours • Torque: 75 cNm • Maximum panel thickness 11 mm • Insulation resistance : 4,000 MΩ at 500 VDC MATERIALS • Plated brass bezel finished in bright chrome, black or satin grey and molded polycarbonate rear body The company reserves the right to change specifications without notice. All LED characteristics are dependent upon environmental conditions. Therefore published data should be considered nominal a

Open the catalog to page 1

Ø14 mm panel mount LED indicators ELECTRICAL SPECIFICATIONS Voltage STANDARD LED INTENSITY LED COMPONENT SPECIFICATIONS Operating Voltage Operating Current (Min to Max) Forward Voltage Bi-color (Typical) (Red/Green) Tri-color (Typical) (Red/Green/Yellow) Bi-color - The color is changed by reversing the polarity of the supply voltage. Tri-color - The indicator has red and green LEDs, when both connected yellow is produced. * Customer to supply resistor for desired operating current. ADDITIONNAL INFORMATION ON LED COMPONENTS • The operating voltage must not be exceeded by more that 10% as...

Open the catalog to page 2

Ø14 mm panel mount LED indicators BUILD YOUR PART NUMBER MOUNTING HOLE BEZEL STYLE Rear epoxy Pins BEZEL FINISH Rear epoxy Wires Short body Pins Short body Wires Fixed Light Bright Chrome Satin Grey Hyper Bright Green Super Bright Blue Hyper Bright Yellow Super Bright White Hyper Bright Orange Super Bright Green Red/Yellow/ Green Super Bright Yellow Red/Green/ Blue* * Terminals option 5 and common anode only ABOUT THIS SERIES ANODIZED FLUSH Common cathode Common anode Notice: please note that not all combinations of above numbers are available. • Gold faston terminal denotes anode (+),...

Open the catalog to page 3

Q14 series Ø14 mm panel mount LED indicators PROMINENT BEZEL SOLDER LUG/FASTON REAR EPOXY WIRES REAR EPOXY PINS SHORT BODY WIRES SHORT BODY PINS

Open the catalog to page 4

Ø14 mm panel mount LED indicators FLUSH BEZEL SOLDER LUG/FASTON REAR EPOXY WIRES REAR EPOXY PINS SHORT BODY WIRES SHORT BODY PINS

Open the catalog to page 5

Q14 series Ø14 mm panel mount LED indicators RECESSED BEZEL SOLDER LUG/FASTON REAR EPOXY WIRES REAR EPOXY PINS SHORT BODY WIRES SHORT BODY PINS

Open the catalog to page 6

Q14 series Ø14 mm panel mount LED indicators CUSTOM ENGRAVING Some common codes are listed above, for your custom requirements please contact APEM. Unless specified standard engraving with white infill will be supplied. Suffix the part number with legend code : CABLE LENGTH AND CONNECTOR For custom cable length and connectors contact APEM.

Open the catalog to page 7