PANEL SWITCHES Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO DISTINCTIVE FEATURES Large actuator With illuminated ring Momentary NC/NO Solder lug, flying lead or cable terminals Marking available on request ENVIRONMENTAL SPECIFICATIONS • Optional front panel sealing : IP67 according to IEC 60529 • Robustness : IK06 according to EN 62262 (1 joule) • Operating temperature : -30 °C to +85 °C (-22 °F to +185 °F) ELECTRICAL SPECIFICATIONS • Max. current/voltage rating with resistive load : 1 A 30 VDC • LED voltage : 12 VDC, 24 VDC or 48 VDC If not supplied by APEM, a resistor must be series-connected by the user : see LED component specifications below. • Initial contact resistance : 100 mΩ max. • Insulation resistance : 10 MΩ min. at 500 VDC • Dielectric strength : 500 Vrms 50 Hz min. between terminals 1,000 Vrms 50 Hz min. between terminals and frame • Electrical life : 250,000 cycles at full load LED COMPONENT SPECIFICATIONS LED color Forward current Resistor value = supply voltage - LED forward voltage The company reserves the right to change specif

PANEL SWITCHES AV series Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO GENERAL SPECIFICATIONS • Travel : 2.5 mm ± 0.3 mm (.003) • Operating force : 5 N ± 2 N • Torque : 10 Nm max. • Panel thickness : 1 (.039) to 6 mm (.236) max. • Low level or mechanical life : 1,000,000 cycles • Hand soldering : 350 °C (662 °F), 5 seconds max. CONNECTIONS WIRE COLORS (F OUTPUT) 1 Green LED+ Blue LED+ CABLE COLORS (C OUTPUT) • Case : polyamide, glass filled • Contacts : silver Green LED+ • Bushing : see following pages Blue LED+ • Actuator : see following pages • Elastomeric membrane :...

Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO BUILD YOUR PART NUMBER BASIC PART NUMBER BUSHING DIAMETER Solder/ quick-connect Flying leads *This version is with NO contact only RING COLORS FLYING LEAD PROTECTION No protection and/or no flying leads Heat-shrink sleeves Overmolding + flying leads Opal white *non-illuminated only BUSHING AND ACTUATOR MATERIALS FLYING LEAD/CABLE LENGTH No flying leads / no cable ABOUT THIS SERIES Nickel plated brass Aluminum & natural anodizing Aluminum & blue anodizing Aluminum & black anodizing Aluminum & green anodizing Aluminum & gold anodizing...

Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO Plastic hex nut 36 (1.417) across flats FLAT ACTUATOR - SOLDER LUG TERMINALS * Select LED color on previous page - No LED resistor supplied on this model. FLAT ACTUATOR - FLYING LEAD TERMINALS Plastic hex nut 36 (1.417) across flats 2.20 (.086) * Select LED color & resistor on previous page. Wire colors : black: NC, orange: NO, red: LED anode (+), blue : LED cathode (-) CAV5DT-2 ech : 0.8 Plastic hex nut 36 (1.417) across flats FLAT ACTUATOR - CABLE TERMINALS PANEL SWITCHES * Select LED color & resistor on previous page. CAV5D...

Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO FLYING LEAD PROTECTION BASIC P/N No protection and/or no flying leads Heat-shrink sleeves Tube + epoxy FLYING LEAD/ CABLE LENGTH BASIC P/N No flying leads / no cable Length 20 cm (standard) Length in centimeters RING COLORS BASIC P/N 6 Red 7 Opal white (std) 8 Translucent 9 Orange * non-illuminated only Blue Black * Green Grey * Yellow BUSHING/ACTUATOR MATERIALS BASIC P/N Nickel plated brass Aluminum & green anodizing Aluminum & gold anodizing Aluminum & natural anodizing Aluminum & blue anodizing Aluminum & black anodizing...