THANK YOU FOR PURCHASING THIS PRODUCT Behlen Country has been in the business of providing quality products for more than 75 years. Our products will provide many years of service when maintained by the owner and used in accordance with the capabilities of the product. For questions about this product, or for parts inquiries, please contact our Customer Service Center listed below. NOTE: Bottom of kennel has 1½” clearance to ground. Typical Dog Kennel Setup The dog kennel latch system has two main components, the Latch #2208063 and the Catch Plate #38600729. The latch will attach to the outer tube in the doorway of the front panel, this tube has two holes in it. Loosely attach with two carriage bolts and lock nuts. The Catch Plate is attached to the door using the one hole in it. Loosely attach this with one carriage bolt and lock nut. Close the door and adjust both latch components for smooth latching. If door doesn’t want to latch smoothly when closing, lubricate the handles with a couple of drops of oil. Tighten all bolts on the latch assembly. (See illustrations) To attach panels, one side of the clamp will have to be inserted between the wire and the vertical tube before the other side of the clamp can be attached. A clamp should be attached (as shown at right) one at the top and one at the bottom of each panel. CUSTOMER SERVICE CENTER PO Box 569 Columbus, NE 68602-0569 F-19029-7

Optional Powder Coat Wire Mesh Top for 5’ x 10’ Dog Kennel 38140017 Optional Powder Coat Wire Mesh Top for 10’ x 10’ Dog Kennel 38140027 Optional Hot-dipped Galv. Wire Mesh Top for 5’ x 10’ Dog Kennel 38140019 Optional Hot-dipped Galv. Wire Mesh Top for 10’ x 10’ Dog Kennel 38140029 For proper setup, have the wire facing the outside of the kennel. For tops to fit properly, dog kennels must be set up as shown. Each top panel will have to be attached by using the butterfly clamps supplied. To attach the clamp, one side of the clamp will have to be inserted between the wire and the vertical tube...