*myagriexpo

1260 and 1262

Product catalog summary

Product Overview: The document describes the FLEXBALL Italiana WR Controls Group's electronic throttle pedals, models 1260 and 1262. These pedals are designed for various vehicles and can be mounted on the floor or wall. They feature a triple torsion spring for idle position return and are constructed with an aluminum frame. The 1260 model has an aluminum paddle, while the 1262 model has a plastic paddle. The pedals are equipped with a Hall effect sensor for position measurement and offer multiple electrical interface options, including voltage channels, PWM, current, and CANBus.

Physical and Mechanical Specifications: The pedals have a stroke of 17° and dimensions suitable for versatile mounting. They are designed to operate in temperatures ranging from -40°C to +80°C and can be stored between -40°C and +110°C. The operational life is rated at 5 million cycles at 25°C. The pedals weigh 1.20 kg and feature a double safety return spring with specific torque values at idle and wide-open throttle (WOT).

Electrical Specifications: The pedals use a Hall effect sensor with a 5 Vdc power supply. The electrical signal is galvanically insulated, with a resolution of 10 bits and an update rate of 0.1 ms. The correlation between two signals is better than 1% across the pedal range. Current consumption is less than 10 mA per channel, with a minimum load resistance of 4.7 kΩ and a maximum load capacitance of 10 nF.

Interface Configuration: The document lists various interface configurations for the pedals, including single and dual voltage channels and options with an idle validation switch (IVS). The standard electrical cable length is 0.5 meters, with customizable lengths and connectors available upon request.

Pinout Details: The pinout for the standard connector (Tyco Econoseal J 6) is provided, detailing the color coding and function of each pin for both voltage signal and IVS configurations.

Catalog excerpts

Electronic throttle pedal Electronic throttle pedal Aluminium throttle pedal floor or wall mountable. This series of pedals is intended for any kind of vehicles. A triple torsion spring is incorporated for idle position return. The frame of this series of pedals is made of aluminum; paddle of 1260 is in aluminum and paddle of 1626 is in plastic. They can be either floor or wall mounted. The electronic circuit is fully protected against water and any kind of contaminants. Thanks to its particular enclosure, a high IP is guaranteed and environmental contamination is minimized. Measuring position is through Hall effect sensor with one or two channels. It is available with any kind of electrical interface: 1 or 2 voltage channels, with or without idle validation switch, PWM, current, CANBus. Upon request, they can be configured with the desired electrical cable length, number of poles, type of connector. PHYSICAL DIMENSIONS AND MOUNTING INSTRUCTIONS =

Open the catalog to page 1

1260 AND 1262 ELECTRONIC THROTTLE PEDAL > 2 di 2 ELECTRICAL SPECIFICATION (VERSION WITH VOLTAGE SIGNALS) MECHANICAL SPECIFICATION • • Operating temperature • Storing temperature • Weight • Return spring • Spring torque at idle • Spring torque at WOT • Hysteresis • Travel angle • Sensor • Power supply • Electrical signal • Resolution • and update rate in case • Correlation of 2 signals -40 .. + 80 °C –40 .. +110 °C 1.20 kg Double safety spring 2.5 Nm 4.5 Nm 0.15% on read value Hall effect 5 Vdc ±10% ratio metric Galvanically insulated 10 bit, update rate 0.1 ms better than 1% in the whole pedal...

Open the catalog to page 2