Electronic throttle pedal This series of plastic wall mounted pedals is intended for any kind of vehicles A triple concentric torsion spring is incorporated for idle position return. Made of polyarylamide (PAA) reinforced with 60% fibreglass, pedal 1270 is very robust and reliable, therefore it can be mounted also on heavy duty construction machines or military vehicles. Environmental contamination is minimised thanks to the joint combination of the gasket with the mounting flange which segregate the cabin from the engine area. The full sealing between the cabin and the engine area is widely appreciated in the military sector where the vehicles are specified to travel with the cabin up to one meter below the water level. Measuring position is through Hall effect sensor with one or two channels. It is available with any kind of electrical interface: 1 or 2 voltage channels, with or without idle validation switch, PWM, current, CANBus. Upon request, pedal 1270 can be equipped with the kickdown option and can be configured with the desired electrical cable length, number of poles, type of connector. PHYSICAL DIMENSIONS AND MOUNTING INSTRUCTIONS 65 Electric wire outgoing to the ECU Wall Sealing (non supplied) (*) Window on the wall to insert the throttle pedal before the fixing FLEXBALL I T A L I A N A WR CONTROLS GROUP

1270 ELECTRONIC THROTTLE PEDAL > 2 di 2 ELECTRICAL SPECIFICATION (VERSION WITH VOLTAGE SIGNALS) • Sensor • Power supply • Electrical signal • Resolution • and update rate in case • Correlation • of 2 signals • Current consumption • Minimum load resistance • Maximum load capacitance MECHANICAL SPECIFICATION • Operational life (at 25 °C) • Operating temperature • Storing temperature • Weight • Return spring • Hysteresis • Travel angle 2 million cycles –40 .. +80 °C –40 .. +110 °C 0.70 kg Triple safety spring 0.15% on read value 25 degrees Hall effect 5 Vdc ±10% ratio metric Galvanically insulated...