Electronic throttle pedal This series of plastic floor mounted pedals is intended for any kind of vehicles A double concentric torsion spring is incorporated for idle position return. Made of polyamide PA66 reinforced with 30% fibreglass, pedal 1280 is very robust and reliable, therefore it can be mounted also on heavy duty construction machines, agriculture machinery or military vehicles. The electronic circuit is fully protected against water and any kind of contaminants. Thanks to its particular enclosure, a high IP is guarantee for the whole pedal and environmental contamination is minimized. Measuring position is through Hall effect sensor with one or two channels. It is available with any kind of electrical interface: 1 or 2 voltage channels, with or without idle validation switch, PWM, current, CANBus. In order to adapt to the most ergonomic position, the paddle can be adjust to different angles (A=): 27°, 36° and 45°. Upon request, pedal 1280 can be equipped with the kick-down option and can be configured with the desired electrical cable length, number of poles, type of connector. Pin to adjust the pedal angle (A) FLEXBALL I T A L I A N A WR CONTROLS GROU

1280 ELECTRONIC THROTTLE PEDAL > 2 di 2 PHYSICAL DIMENSIONS AND MOUNTING INSTRUCTIONS Adjust the friction of mechanical hysteresis with an hexagonal key of 4 mm. The access is from the bottom of the pedal. 79 Screw to tune the friction ELECTRICAL SPECIFICATION (VERSION WITH VOLTAGE SIGNALS) MECHANICAL SPECIFICATION • • Operating temperature • Storing temperature • Weight • Return spring • Hysteresis • Travel angle • Sensor • Power supply • Electrical signal • Resolution • and update rate in case • Correlation • of 2 signals • Current consumption • Minimum load resistance • Maximum load capacitance...