1400 Multiaxis electronic control
1 / 4Pages

Multiaxis electronic control It is a modular system where different types of electronic axis controllers and electronic devices are mounted side by side It can work as a multifunction interface towards high level supervisory control systems. It can operate as a stand alone fully programmable device which autonomously controls the whole process: from the elaboration of input signals to the generation of power commands for the hydraulic distributors. It can operate as a remote controller: the commands acquired locally, are sent via CANBus to decentralized peripherals which generate signal and power commands to the machine. Several interfaces are available: voltage, current, PWM, CANBus. SINGLE AXIS ELECTRONIC CONTROLLER Standard stroke is +/- 20 degrees, measured with respect to the lever’s central position. Device root code (DDDD): 1410 Available in the following versions. lever with return to central position: code 1410 • Control lever with friction: code 1411 • Control Control with friction and neutral detent at the centre of the stroke: code 1412 • Control lever with syringe for the release from neutral position: code 1413 • Control lever • lever with friction and detents in any position defined by the customer: code 141X For the different versions and combination of switches and LEDs, please refer to next

JOYSTICK DUAL AXIS ELECTRONIC CONTROLLER Device root code (DDDD): 1420 Stroke on direction N-S: +/–20° Stroke on direction E-W: +/–15° For the different versions and combination of switches and LED, please refer to next section. PANNEL CONTROLLER FREELY CONFIGURABLE It is configurable according to the customer specification and can be combined with switches, rollers, potentiometer, LED. Device root code (DDDD): 1430 For the different versions and combinations of switches, rollers, LED, a joint drawing between the customer and Flexball must be specified. EXTENDED REMOTE CONTROLLER The...

ELECTRIC AND ELECTRONIC ACCESSORIES Knob with push button (400 mA) 1 digit code (K) defines the configuration of the knob that can be mounted either on the single axis controller or on the joystick: Knob configuration Knob without push button and without LED Knob with push button (400 mA) Knob with push button (400 mA) and with LED MACHINE INTERFACE CANBUS Electronic connector is placed under the base on the control. It is a standard TE M12 4 poles A code connector. Electronic connector is placed under the base on the control. This is a standard TE connector Vertical HDR for printed circuit...

The device which has the electronic interface is always mounted on the left side of the “package”. 1 digit define the type of interface. Type of machine interface 1 Tyco Vertical HDR 14 poles Maximum 8 channels (8 solenoid valve per system). Further information is in a separate document CanBus protocol is described in a separate document CODING SYSTEM Device D Special projects – The code is composed of 14 digits which correspond to the following: D defines the product type and its configuration DDDD = 1410 single axis DDDD = 1420 dual axis DDDD = 1430 panel control DDDD = 1440 extended...