Catalogs >
Flexball Italiana >
610 ELN control lever

610 ELN control lever
1 / 2Pages

Catalog excerpts

610 ELN control lever Electronic Single axle control It is a single axle control suitable for a variety of applications, inlcuding industrial vehicles, agricultural machines, heavy duty machines and any other kind of special machines. It is equipped with a clutch which can be adjusted from factory and a neutral detent is also available. With the neutral detent, it works as a FNR control. Without the neutral detent, it works as a throttle control. Multifunctional handle is available with up to 6 switches and with the dead man function. The electronic circuit is fully protected against water and any kind of contaminants. Thanks to its particular high IP enclosure, the control can be mounted either in cabin or in open air and it can operate in harsh environments with continuous operation, high reliability and long working life. Measuring position is through Hall effect sensor with one or two channels. It is available with any kind of electrronic interface: 1 or 2 voltage channels, with or without idle validation switch, PWM, current, CANBus. Wall mounted M12 connectors are positioned on the lower part of the lever. PHYSICAL DIMENSIONS AND MOUNTING INSTRUCTIONS 8

Open the catalog to page 1

Available multifunction handles: 1725 series or 1730 series both with or without dead man function. E ELECTRICAL SPECIFICATION (VERSION WITH 2 VOLTAGE CHANNELS) MECHANICAL SPECIFICATION • Operational life (at 25 °C) • Operating temperature • Storing temperature • Weight • Hysteresis • Travel angle 1 million cycles -40 .. + 80 °C -40 .. + 110 °C 0.75 kg 0.15% on read value +/- 20 degrees with respect to neutral position • Sensor • Power supply • Electrical signal • Resolution and update rate in case • Correlation of 2 signals • Current consumption • Minimum load resistance • Maximum load...

Open the catalog to page 2