Combined seeder KPA-2…5
4Pages

{{requestButtons}}

Catalog excerpts

Combined seeder KPA-2…5 - 1

Research and Production Company 72319 Zaporizhia region, the city of Melitopol, B. Khmelnytskyi Ave., 27 tel. (0619) 43-60-28, 43-11-77 tel./fax (0619) 43-77-71 E-mail: mail@rosta.ua, web-sites: www.rosta.ua, www.rostaltd.com

Open the catalog to page 1
Combined seeder KPA-2…5 - 2

weeds, very convenient (especially Introduction at reverse travel) when weed management, grown Combined seeders KPA-2; plants. Tilting depth is (VPS 27/1-10/4) produced in in a row of cultivated KPA-3; KPA-4; KPA-5 up to 4 cm. Additional adjustment of approach angle is U30952138-001-2004 to plant small-seeded vegetables accordance with Specification required. in greenhouses, seedbeds as well as in the outdoors. Multi-purpose design of these units has been achieved by combiningproduct and storage rules seeders for smallMaintenance of the manual cultivator KR-1 and seeded crops SMK-2; SMK-3;...

Open the catalog to page 2
Combined seeder KPA-2…5 - 3

Preparation of the seeder to operation Set the required sowing rate with placing the necessary sawing bush on the shaft. Adjust the arrangement of bush restrictor for the required amount of seeds. Check and adjust, if necessary, the sowing rate through running the seeder filled with seeds on a flat surface. ATTENTION!!! For normal operation of the seeder do not fasten the section mounting bolt on the seeder body through rubber ruing. Section shall depart from the axle on drive shaft freely. Sowing Prior to sowing mark a seed bed. The seeding is made into well-tilted soil using drilling...

Open the catalog to page 3
Combined seeder KPA-2…5 - 4

Angle between holes, Distance between seeds in a row, cm Q-ty of seeds per linear meter, pcs No. of mark at the template Figure 1. Bracket of the SMK seeder III. Ø Cultivator is47multi-purpose agricultural tool enabling performance of necessary a 2 1 360 Drill 1 hole operations when cultivation of vegetable and holes acrosscrops. 2 other tilled according to any 4 24 180 Ø Product is made base2on modularity principle – special assemblies fulfilling template specific process functions are 120 fastened to multi-purpose base frame. The frame 6 15 3 1 1,9,17 design enables to install several 90...

Open the catalog to page 4

All Garmach catalogs and technical brochures