ROTONDO TRACTION SWITCH The ROTONDO traction switch is suitable for use as a setpoint generator for electrically powered vehicles and • Different shaft versions are available (single-sided and through shaft) other systems. Its design and its housing with an inte- grated mounting flange make it very easy to install. The • Membrane-sensor technology version with a through shaft is used for applications with • Potentiometer analogue output (V characteristic) two butterfly knobs. A version with a single shaft on one side is also available. Besides the analogue signal for the travel speed setpoint, the traction switch also delivers two digital direction signals. for travel speed • Nominal supply voltage: 24 VDC, separate potentiometer supply max. 12 VDC • Available with active-low or active-high digital signals • Protection class: IP 54 (except for the connector) • Various butterfly knobs available Subject to change without notice | Version of 12 21 Gebrüder Frei GmbH & Co. KG 72461

Characteristic curve Continuous axle Technical data Mechanical data Dimensions Mechanical movement Actuation Contact system 39-01-2080 Electrical data Rated operating voltage Power consumption Supply voltage potentiometer Resistance track potentiometer Max. current, analogue output Digital signal Output Max. permissible voltage Max. permissible current Operating conditions Operating temperature range Service life Vibration test EMC Degree of protection according to DIN 60529 See drawing 2 x 48° Square axle of size 6 x 6 mm Cable with 8-pin Molex Mini-Fit, Jr.™ 24 VDC (16.5 to 32 VDC) < 20 mA...