STIPO TRACTION SWITCH Thanks to its small outside diameter measuring just • Non-contacting Hall sensors 30 mm, the STIPO traction switch is particularly suitable • Digital outputs for direction and zero- for installation in pipes or housings with limited installa- position signals tion space. Despite its compact dimensions, a complete • Active-high and active-low logic available microcontroller system and Hall sensor system are inte- • One / two analogue outputs for travel speed grated into the housing. The dual-redundancy sensors • Different characteristics available offer the highest degree of safety. To protect the Hall sensors against external magnetic fields, the housing incorporates a solid steel core. (V-, Z-, or X-characteristics) • Suitable for safety-related applications according to EN ISO 13849 Depending on the particular variant, the traction switch provides one or two analogue signals, two digital • Protection class: IP 54 (front) direction signals and a digital zero-position signal. • Various butterfly knobs available • EMI/EMC according to DIN 12895 Subject to change without notice | Version of 01 24 Gebrüder Frei GmbH & Co. KG 7246

Characteristic wig-wag Characteristic single-ended Electrical rotation angle Operating temperature Protection class Life time Dimensions [mm] +10.5 VDC to +32.0 VDC max. 25 mA see separate user manual max. 5 mA max. 32 V / 20 mA 45° each direction (± 1.5° tolerance) 41.5° each direction (± 1.5° tolerance) -28°C to +65°C IP 54 (except connector) 4,000,000 cycles Technical data Operating conditions Operating voltage Power consumption Output voltage Output current Digital signals Mechanical rotation angle Contacting* depends on the variant *No lateral forces may act on the upper circuit board. An...