Tensioned roof for slurry silo
Tensioned roof for slurry silo
Catalog excerpts
Tensioned roof for slurry silo THE solution for covering round silos A tensioned silo roof is an excellent way to cover a slurry silo. This cover can be used for steel, concrete and wooden silos. The materials used are resistant to slurry and wastewater. The tensioned roofs are normally made of Genatex® 850, a high quality reinforced PVC foil. in two standard colours grey or green. All used steel parts are stainless steel 304 or 316. The middle column is made of hardwood. The valance is galvanised. The tensioned roof has a standard angle of 17°. However, other angles are also possible on request. Your customised roof The tensioned roofs are made to measure. We use three standard sizes manholes. You can specify the number of manholes. You will get a roof customised according to your wishes for your silo. Meets all legal standards All our tensioned roofs are manufactured, and if we install, installed according to the guidelines of de BRM and Euro standards. The expected life time is 10 years. Genap BV – PO Box 27 – NL 7040 AA ’s-Heerenberg – T +31 314 661644 - [email protected] – www
Open the catalog to page 1All Genap catalogs and technical brochures
Air tubes1 Page
Slurry lagoon1 Page
Steel mesh storage tank1 Page
GenaFlexstore®1 Page
Siloliners1 Page
Toolbox1 Page
Steaming sheets1 Page
Silofloat1 Page
Silo-liners1 Page
Short panels1 Page
Pillosol1 Page
In-outlets-silo1 Page
Hydroponics1 Page
Genafloat1 Page
Extreme kit1 Page
Closed-water-reservoir1 Page
Aquatex-extreme-liner1 Page
Air-tubes1 Page
Silage clamp covers1 Page
Airhat1 Page
