ATLANTIS WATER METER www.hidroconta.com

WATER METER ATLANTIS Hydrodynamic design The Hidroconta Atlantis water meter is based on the principle of single speed and sinlge jet. The water enters into the measuring chamber forming a single jet that pushes the vanes of the turbine, producing its movement. The turn of the turbine is transmitted by magnetic transmission, through a shaft and gears, to a head that accumulates in its totalizer the volume of water that has circulated through the meter. QHigh protection Atlantis has a security system that prevents the rotation of the fixing ring of the water meter and the access to the adjustment...

WATER METER ATLANTIS o Homologation MID The Atlantis water meter from Hidroconta has the metrological requirements based on the Directive 2014/32 / EU, so they are normally used for the totalization and control of domestic water consumption. In Hidroconta we make strict tests in the counters that assure its quality and its precision. Water engineering When the water go through the meter, the propeller begins to rotate. The axis propeller transforms the rotating motion into a rotating magnetic field. This magnetic field rotates the watch gears that end in an indicator device, which, by means of...

WATER METER ATLANTIS Dial Lining figures dial Rotary starwheel for leak detection. MID approval for potable water. Technical specifications - For cold water up to 30 C˚. - Copper alloy body. - Direct reading in 7-digit roller counter indicating m3. - Completely dry and unsumerged dial. - Magnetic transmission protected against external magnetic fields. - The dial can be turned manually: For reading in any position. - MID approval for potable water. Directive 2014/32 / EU. - Straight sections are not necessary at the meter input or output U0-D0. - Inductive pulse output pre-equipment Al rights reserved....

WATER METER ATLANTIS Fixing ring Fixing ring Separated plate Copper alloy Fitting tube Copper alloy Copper alloy Al rights reserved. © Copyright. 2016 HIDROCONTA. S.A. WHEN WATER COUNTS

©WATER METER ATLANTIS metering technology Al rights reserved. © Copyright. 2016 HIDROCONTA. S.A. WHEN WATER COUNTS

WATER METER ATLANTIS Working conditions Maximum permissible error Room temperature Technical specifications Pressure loss curve Al rights reserved. © Copyright. 2016 HIDROCONTA. S.A.

WATER METER ATLANTIS Flow error curve Pulse emisor DIRECT AND INDIRECT PULSES OUTPUT Pulse value Type of output Maximum current for contact closure Maximum polarization voltage Contact resistance closed Contact duration closed Insulation voltage test Standard 1 pulse = 10 l Potential-free contact 100mA 60V 5 Ohms maximum 100 mS 3750 Vrms Straight sections are not necessary at the Atlantis input or output U0-D0. Al rights reserved. © Copyright. 2016 HIDROCONTA. S.A. WHEN WATER COUNTS

WATER METER ATLANTIS Installation instructions - The meters must always be full of water when operating, minimum presure 0,3 bar, and installed below the slope of the rest of the pipeline. This stops air pockets from forming inside. - Fit a valve upstream from the meter to facilitate maintenance or repair. - If there is air in the pipeline, suckers must be fitted to avoid incorrect readings. If the water in the pipeline contains large suspended particles, an initial screening filter should be installed. - Do not force the meter during assembly; avoid tension or torsional stress, especially to the...

©• hirlrn conta metering technology ATLANTISIwATER METER Ctra. Sta Catalina, 60 Murcia (30012) Espana www.hidroconta.com Hidroconta disclaims responsibility for errors in the information contained in this document, which may be modified without notice. Al rights reserved. © Copyright. 2016 HIDROCONTA SA