Hydro-Probe SE
4Pages

Digital Microwave Sensor for Measuring Moisture or Dissolved Solids

Hydro-Probe SE Microwave sensor for moisture or dissolved solids The Hydro-Probe SE is a high temperature microwave sensor designed for use in liquids such as concentrates, solutions or any process where the level of dissolved solids requires measurement. The sensor is manufactured from materials that are safe for food contact enabling installation in food production or similar environments. Typical applications include measuring in an evaporator when reducing liquids or any process where an exact measurement of moisture in a liquid is required. Designed for installation in a pressurised...

RS485 If Hydro-Link protocol implemented Interface Options Control System RS485 Hydro-View Other Hydronix sensors can be used elsewhere in the process if required A combination of up to 16 sensors can be connected on the RS485 network Ethernet Hydro-Hub USB Sensor Interface Module RS232 PC running Hydronix Hydro-Com Software Typical Applications: Hydronix sensors can be used in many industries that require moisture to be measured before further processing takes place. Typical examples include applications that use a Calandria or a spray dryer. Reducing Liquids The concentration of a liquid...

Technical Information Construction Refresh Rate Body: 316 Stainless Steel. Pressure: Full vacuum to 6 Bar gauge. Faceplate: Ceramic. Electronics Section Protection: IP67. Analogue Outputs O-Rings: EPDM. Two configurable 4-20mA or 0-20mA current loop source available for Unscaled, moisture, Brix or material temperature. Fixing The sensor must be placed in the flow of material and is attached to the vessel using the bolted flange. Digital (Serial) Communication Opto-Isolated RS485 2-wire port. RS232, Ethernet and USB adaptors available. Measurement Range Programming details to access sensor...