OROFLEX' 10Classic Extruded Rubber Lay Flat Hose Specially Designed for Water Transfer Applications: Designed and recommended for water transfer and general pumping duties in irrigation, mining, construction, sewage, draining systems, water bypass operations and cable sheaths. Made from circularly woven 100% high tenacity synthetic yarn, completely protected and locked-in by a tough, highly resistant synthetic nitrile rubber & PVC blend, extruded through the weave and forming a single homogenous construction without the use of glues or adhesives. a. Ultimate Tensile Strength of the lining: Minimum guaranteed value of 1,500 psi (10,500 kPa). b. Ultimate Elongation: 400% minimum. c. Accelerated Aging Test: The tensile strength and ultimate elongation of the vulcanized rubber compound have been tested with oxygen at a pressure of 300 psi +/- 10 psi (2100 kPa +/- 70 kPa), and a temperature of 70 degrees Celsius +/-1 degree (158 °F +/- 18 °F) for a period of 96 hours, after which the properties of the rubber are at least 60% of the original values. The OROFLEX 10 hose will extend the lifetime of your application when under extreme conditions, where abrasion is the main concern. Abrasion resistance > 2000 cycles. -22°F (-30°C) to 176°F (80°C). Special versions for higher and lower temperatures available upon request. No visible signs of cracking appear on the lining or cover when tested in accordance with ASTM D518 Procedure B, 100pphm/104°F (40°C). Exposure to seawater and contamination by most chemical substances, hydrocarbons, oils, and greases has no effect on the short or long term performance of the hose. A chemical resistance chart is available and TIPSA will supply specific chemical resistance data when requested by the purchaser for unique applications. As requested by purchaser; Camlock, Bauer, Perrot, Victaulic, Storz, etc. TIPSA - Kuriyama Group • Av. de Barcelona, 20 • 08970 Sant Joan Despi / Barcelona, Spain

tipsa /I\ Kuriyama Group Physical Properties: Part The actual diameter of these hoses may differ slightly from the nominal diameter specified in this chart to make sure that they can be properly assembled with the couplings. For diameter tolerance questions please contact your distributor or directly to TIPSA. (1) Hoses to be assembled with Camlock couplings (2) Available on minimum order quantity. tipsa reserves the right to modify any specification without prior notice to meet or exceed changing standards. Customers are advised that special diameters or construction characteristics can be produced...