HIGH-TECH COMPONENTS FOR AIR DRILLS

HIGH-TECH COMPONENTS FOR AIR DRILLS COUNTING SEEDS...NOW POSSIBLE The latest generation sensors by MC Elettronica, capable of counting any type of seed at almost any speed. The new technology applied is based on the latest generation of infrared optical sensors coupled with a 8 bit microprocessor. After more than 3 years development we have finally tuned the counter up to a limit never achieved before. In fact, this sensor is able to compensate dust, detect the type of seed in transit and count seeds of less than 1 mm diameter at an incredible speed rate (650 seed/sec).

seed counter sensor Conventional distribution Kg/ha Precise, modular and versatile photocell, allows COUNTING and testing the seeds passage for each single row for seed drills, with automatic dust compensation. For proper operation of the seed count sensor, it is necessary to set the seed type before starting processing. In addition, the PRO-SEEDER photocells are connected to the respective electronic control unit and perform an automatic test of correct functionality. ADVANTAGES The seed sensor connected to the GATEWAY ECU allows you to: • Locate sowing anomalies. • Have dynamic dust compensation,...

BLOCKAGE SENSORS seed/fertiliser flow monitoring ANALOGIC VERSION CAN-BUS VERSION The BLOCKAGE sensor to be installed on pneumatic or mechanical seed drills, allow the operator to check the ON/OFF flow or clogging of granular fertiliser or seeds, also in condition of high dust, thanks to the system ADC (Automatic Dust Compensation) provided that the pipe is the same diameter of the photocell. It’s available in analogue and CAN-BUS version. On the photocell body 1 or 2 leds indicate(s) when it is powered, the output signal and the cleanings status. For photocell cleaning, a rapid U-shaped clip...

2-ways rows shut-off valve The new PRO-VALVE is the latest generation shut-off valve with the possibility of integrating an optical sensor to detect and count the passing seeds. The advantage is to have a single component with two functions, reducing the overall dimensions and costs. This valve is the ultimate development of shut-off valve from MC Elettronica: incorporating more than 25 years of experience in sensors and shut-off valves technology, surpassing the most stringent standards in terms of cycles, resistance to dust and water aggression. This valve can be integrated in any control system...

3-ways rows shut-off valve The motorized valve TCS-32 3 ways allows the ON/OFF function over the seed pipes. Thanks to the internal rotating “guillotine” system ; the seed flow is divided in two possible directions: or the ground discharge (ON) or the return into the hopper container (OFF). Ideal for air seed drills (positive pressure) , allows the operator to cut the flow when is requested the “Tramline” function. TCS-32 available in 2 different versions: • 3-way analogue version (two-wire with polarity reversal) • 3-way CAN-BUS version (for “Daisy chain” configuration) ADVANTAGES • Modular:...

HIGH-TECH COMPONENTS FOR AIR DRILLS SEED SENSORS COMPARISON BLOCKAGE SENSOR CAN-BUS, or digital output Automatic Dust Compensation Extended hose fitting range: D25, 30, 32, 38 Microprocessor BUS Management Seed Counting Canola Seed Detection SHUT-OFF VALVES COMPARISON Input Command Phacelia & Small seeds compatible # of ways Internal Passage Hose fittings

Via E. Fermi, 450/486 (Z.A.I.) 45024 Fiesso Umbertiano (RO) - ITALY Tel. +39 0425 754713 [email protected] www.mcelettronica.it Follow us on: