WATER APPLICATION SOLUTIONS FOR CENTER PIVOT IRRIGATION NO OTHER END OF PIVOT SPRINKLER WORKS IN THE LOW PRESSURE RANGE OF 15-60 PSI (1-4 BAR) AND PROVIDES UP TO 10 ADDITIONAL IRRIGATED ACRES (ON A 1/4 MILE PIVOT). The new Nelson R55VT uses a patented variable torque speed governing system that allows the plate to maintain a constant rotation speed across a broad range of nozzle sizes and pressures. This new design also incorporates snap-fit nozzles, eliminating the need for a retaining pin. UPRIGHT MOUNT (BLUE PLATE) Verify nozzle is secure: check lip in front check notch in back Poor entrance conditions diminish performance. Operating Pressure must be 15-60 psi (1-4 bar) 6” Drain required INVERTED MOUNT (GREEN PLATE) Operating Pressure must be 15-60 psi (1-4 bar) Poor entrance conditions diminish performance. R55i VT The inverted R55i VT, with a specifically engineered green plate, is easier to install and some say it’s effective in helping manage debris that collects at the end of the system.

Body Assy Plate Repair Kit VT 13163— R55i VT Plate/Motor Repair Kit 12886 R55i VT Plate/ 13164 — R55i VT Body Assy Plate Repair Kit 1 1/4" SNAP FIT NOZZLES Suffix Nozzle -X52 #52 Purple R55VT PERFORMANCE (METRIC UNITS) R55i VT PERFORMANCE (METRIC UNITS) R55VT & R55i VT PERFORMANCE DATA HAS BEEN OBTAINED UNDER IDEAL TEST CONDITIONS AND MAY BE ADVERSELY AFFECTED BY WIND, POOR HYDRAULIC ENTRANCE CONDITIONS OR OTHER FACTORS. TEST RISER HEIGHT OF 9 FEET (2.7 METERS) ABOVE MEASUREMENT SURFACE. NO REPRESENTATION REGARDING DROPLET CONDITION, UNIFORMITY, APPLICATION RATE, OR SUITABILITY FOR A PARTICULAR...