OMBRASTOP GEL Shading paint remover for greenhouses • WATER-THINNABLE GELIFIED CONCENTRATE • ADAPTED TO GLASS OR PLASTIC GREENHOUSES • SPRAY APPLICATION PRODUCT IDENTIFICATION DESCRIPTION Concentrated gel for the preparation of sprayable solution especially designed for the removal of OMBRAFLEX shading paint residue on plastic or glass screens or glazing. PRODUCT DATA Density : 1,20 ± 0,05 kg/dm3. Reaction time before drying : 2 to 4 hours depending on the quantity applied and weather conditions. Flash point : Non flammable, waterborne product. pH < 1 : Corrosive product. Product texture : Crystal clear product. Dry film aspect : Matt. QUALITY CONTROL The mentioned characteristics are subject to a factory production control (FPC), realized according to a Quality Management System certified ISO 9001 (2008) and an Environmental Mnagement System certified ISO 14001 (2004). WORKS Maintenance. DESTINATION Functional maintenance of greenhouses. Cleaning to remove product residue (OMBRAFLEX LIGHT, STANDARD, GAP and HORTICOLE) in order to regain full luminous flux. LOCATION Outdoor. LIMITATIONS FOR USE OUTDOOR Product to be used only on outside walls. Do not apply at a temperature below 5°C, at a humidity rate above 80 %, with risk of frost, on humid or condensing substrate (sliding down risk of the product at the bottom of the greenhouse wall) as well in direct sunlight or in high winds (reduction of product action period). Collect the cleaning residues into settling tanks as pre-treatment (sludge separation and neutralization) before discharging into the waste water network. In any case tailing water, should not be used to the greenhouse site irrigation. Cleaning solution adapted to: - A perfect product atomization. - A good soaking time of existing coatings - A long enough reaction time to work on big surfaces. - Residue removal and surface cleaning treated with high pressure water. PRACTICAL COVERAGE 7 to 8 m2 / L of diluted product. This coverage rate depends on spraying tools as well as work habits and can vary from 20 to 30 %.

APPLICATION GUIDELINES Warning : Consult first the Material Safety Data Sheet before handling the product. APPLICATION Spray the diluted product in one coat taking care not to drop or spill any product on the crops. TOOLS On small areas, a 20 L garden sprayer can be used. Any large surfaces will be treated with several types of sprayers, such as electric or automatic ones, and with thermal power or compressed air tank. Check the gaskets condition before each use, and rinse plenty with clear water right after. use a deck washer or a brush to scrub off the plastic screens (If necessary). DILUTION...