The PETKUS Indented Cylinder Separators ZK and ZL are used for the Standard Equipment: sorting and separating of seed, grain, fine and vegetable seeds, corn Bolted housing made of sheet steel and similar agricultural, grained and free flowing granular products. The Indented cylinder with a cylinder casing product is separated according to its length. Discharge trough with transport screw Indented Cylinder Separators can either be used for separating short Drive unit with electric motor grain or long grain, and are available in different sizes and performance Product inlet and product outlets categories. Aspiration connection Short Grain Separation – separating short particles: The short particles settle in the indents. The short particles are transported to the top and Options: discharged into the discharge trough by turning the indented cylinder. Cylinder casings available with various cell sizes Long Grain Separation – separating long particles: The product settles in the indents. The product is transported to the top and discharged into the discharge trough by turning the indented cylinder. The long particles remain in the indented cylinder and are discharged. Advantages: Gentle processing of the product High standard of separating quality Indented cylinder completely covered Simple and quick changing of the cylinder casings Operation smooth and free of vibration Short grain separation Long grain separation The product is moved from the inlet hopper through the turning indented cylinder. Pocket-shaped cells are stamped in the segments of the indented cylinder. The grain settles in these sells depending on the size of the cells. By rotating the indented cylinder the settled grain is transported to the top and falls into the trough at a height dependant on its center of gravity. A transport auger within the trough transports the separated grain to the product outlet. The particles of the product not picked up by the cells of the indented cylinder or which have fallen down below the discharge trough because of their length remain in the indented cylinder and are transported to the corresponding product outlet. The discharges are guided outwards separately. Samples for the two discharges can be taken at the sampling points. PETKUS Technologie GmbH | Roeberstrasse 8 | 99848 Wutha-Farnroda | Germany | Phone:+49 36921-98 

I In-feed (Ø150B) I Zulauf (Ø150B) II Outlet cylinder (Ø150B) II Ablauf Zylinder (Ø150B) III Outlet trough (Ø150B) III Ablauf Mulde (Ø150B) IV Suction connection (Ø150B) IV Besaugungsstutzen (Ø150B) A Cylinder length *Wheat with 3% impurities Technical alteration reserved. PETKUS Technologie GmbH | Roeberstrasse 8 | 99848 Wutha-Farnroda | Germany | Phone:+49 36921-98 0 | E-mai