PRODUCT BULLETIN Subject to technical changes 07/2012 1) Standard-units are designed to fog water based, non-flammable fogging solutions and suspensions. 2) O -units are designed to fog inflammable and non-flammable fogging solutions but not suspensions. 3) m ax flow rate indicates the max motor performance. Leads to wet irregular fog. Not advised for dry fogging. 1) STATIONARY THERMAL FOGGER LARGE TUBULAR FRAME // CONTROL PANEL Empty weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Size (length x breadth x height) . . . . . . . . . . . . . . . . . . . . . . . . Capacity of solution tank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 litres (tolerance 1-2 litres) made of stainless steel Capacity of fuel tank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cubic capacity of engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Automatic ignition . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Electronic ignition coil fed by 4 x dry batteries = 6V Standard starting device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Manual start Flow rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 - 75 l/h (according to nozzle size used)3) Standard flow rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Droplet size spectrum (depending on oil viscosity and nozzle size used) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Optional . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . < 25 μm (oil) / < 60 μm (oil/water) / < 150 μm (water) • Electrical starting device • emote control including automatic cut-off R device and manual start • Turntable FOGGING TECHNIQUE AND APPLICATION Thermal fogging is the generation of ultra-fine droplets in a range of 1-50 μm using thermo-pneumatic energy. Liquid substances are vaporized in the unit and form ultra-fine aerosols by condensing on contact with cool ambient air. Thermal fogging is used for any pest control task where active substances should be uniformly distributed even in inaccessible places, without leaving undesirable residues. The fogging technique is the solution for treating large areas and spaces with a minimum quantity of pesticide solution, less operational work and with little harm to the environment (less residues, no penetration into the ground), e.g. in the field of public health, stock protection, plant protection, disinfection, decontamination, deodorization and cinema effects. pulsFOG Dr. Stahl & Sohn GmbH // Abigstrasse 8 // D-88662 Überlingen // Germany Tel: +49 7551 92610 // Fax: +49 7551 926161 // E-mail: [email protected] // www.pul