JH50
1 /2Pages

JH50

JH50
1 /2Pages

Catalog excerpts

JH50-1

JH50 系列霍尔操纵杆 JH50 Series Hall Effect Joystick 标准尺寸 / Standard Dimensions 面板开孔尺寸(不带安装面板) Panel arrangements (Without mounting panel) Φ32 39±0.1 4-Φ3.5 面板开孔尺寸(带标准面板) Panel arrangements (With standard mounting panel) Abt. 46 ◆ 霍尔型操纵杆 Hall effect joystick ◆ 结构坚固可靠 Firm and reliable structure ◆ 输出信号多样 Various output signals 4-Φ5.2 注:尺寸D在产品选型时根据具体产品规格确定 Dimension D is determined by the product specification 选型指导 / Selection Guide 霍尔操纵杆 / JH50 Hall effect joysticks 特殊编号:用于特殊的客户需求 Special 4-digit part number: For customized products 1 单轴操作 / 1-dimensional coordinate type 2 双轴操作 / 2-dimensionals coordinate type I "前后"型操作 / I figure (Y) directional operation C "十字"型操作 / Cross direction of X and Y operation O 全方位型操作 / Omni-directional 360°operation Q 方型操作 / Square-directional 360°operation S 特殊操作方式 / Special operating directions other than the above-mentioned types 1 带防尘罩,无安装板 / With rubber cover 2 带防尘罩,标准安装面板 / With rubber cover and standard panel 3 带防尘罩,特殊安装面板 / With rubber cover and special panel 工作电压 / 输出信号 Input voltage / output signal 1 输入15~30V,输出0~10V / 15~30V applied, 0~10V output 2 输入9~30V,输出0~5V / 9~30V applied, 0~5V output 3 输入5V±10%,输出0~100%Vcc / 5V±10% applied, 0~100%Vcc output 4 输入15~30V,输出4~20mA / 15~30V applied, 4~20mA output 5 特殊输出信号 / Special signal output 1 弹簧复位 / With spring return device 0 无弹簧复位 / Without spring return device 把手 / Knob B C201A 抓握把手 / C201A knob C C203A 抓握把手 / C203A knob E C103B-C 单开关把手 / C103B-C knob with one switch F C106 单开关把手 / C106 knob with one switch G C102G-C 双开关把手 / C102G-C knob with two switches S 特殊把手 / Special shaped knob 输出特性 / Output characteristics 图1~6可选 1 输出曲线,如图1 / Output characteristic, figure 1 2 输出曲线,如图1 / Output characteristic, figure 2 ……… 6 输出曲线,如图6 / Output ch

 Open the catalog to page 1
JH50-2

JH50 系列霍尔操纵杆 JH50 Series Hall Effect Joystick 一般性能 / General Specifications 操作角度 Operating angle 操作压力(注) Operating force(note) 预期机械寿命 Mechanical life expectancy 工作温度 Operating temperature 储存温度 Storage temperature 防护等级 Protection degree 注:测力点距离安装面板高度为115mm。Note:The measuring point is 115 mm away from the sub-panel for mounting. 电气性能(霍尔电位器) / Electrical Specifications (Hall Effect Potentiometer) 工作电压 Input voltage 输出信号 Output signal 始末输出偏差 Output deviation at both ends 负载电阻 Load resistance 工作电流(无负载) Current consumption (no-load) 独立线性公差 Independent linearity tolerance 介质耐压 Dielectric strength 绝缘电阻...

 Open the catalog to page 2

All SENTOP by Shanghai Sibo M&E Co., Ltd. catalogs and technical brochures

  1. HC60FCA

    2  Pages

  2. PHS5

    2  Pages

  3. PHF8

    2  Pages

  4. C70FCA

    2  Pages

  5. JH22A

    2  Pages

  6. JH80

    2  Pages

  7. HC70FCA

    2  Pages

  8. JH30

    2  Pages

  9. JH25

    2  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.