*myagriexpo

PHS5

Product catalog summary

Overview: The PHS5 Series Pedal by Shanghai Sibo M & E Co., Ltd. is a suspended type pedal incorporating a Hall effect contactless potentiometer. It is designed for applications requiring precise control and reliability.

Standard Dimensions: The pedal features a suspended design with a built-in non-contact Hall sensor. It offers single or double full redundant outputs and has a cable length of approximately 1 meter.

General Specifications: The pedal operates at an angle of approximately 17° with an operating force of 14-25N. It has a mechanical life expectancy of 1,000,000 operations and operates within a temperature range of -40°C to +85°C. The storage temperature range is -40°C to +105°C. It is protected to IP67 standards for electrical parts and can withstand vibrations of 10~55Hz at 98m/s² and shocks of 294m/s². The mass of the pedal is approximately 1100g.

Electrical Specifications (Hall Effect Potentiometer): The pedal supports various input and output configurations, including 5V input with 0~5V output, 9~30V input with 0~5V output, 15~30V input with 0~10V output, and 15~30V input with 4~20mA output. It has a current consumption of less than 25mA and an insulation resistance greater than 1000MΩ at 500V.D.C.

Electrical Specifications (Switch): The switch is rated for 2A/30V.D.C. and 0.5A/125V.A.C. It has an electrical life expectancy of over 100,000 operations and a mechanical life expectancy of over 100,000,000 operations.

Output Characteristics: The pedal provides output signals such as PWM, SSI, RS485, and CANopen. It features an independent linearity tolerance of ±2% and a resolution of 4096 (12 Bit).

Terminal Connection Instructions: The pedal includes ports for SW-, SW+, OUT1, GND1, and VCC1. Connector models available are DTM04-6P and AMP 174359-2.

Special Specifications Available: Custom output signals and connectors are available upon request. For any special requirements, customers are advised to contact SIBO.

Catalog excerpts

PHS5 系列脚踏板 PHS5 Series Pedal 标准尺寸 / Standard Dimensions ◆ 内置非接触式霍尔传感器 Hall effect IC type ◆ 单路或双路全冗余输出 Single or Double full redundant outputs ◆ 悬挂式 Suspended type 选型指导 / Selection Guide PHS5 悬挂式霍尔型踏板 / Means suspended pedal with hall effect contactless POT. incorporated S 单路输出 / Single output P 双路平行输出 / Dual parallel output X 双路交叉输出 / Dual cross output R1 输入5V，输出0~5V（幅值可调） Input 5V, output 0～5V (adjustable signal range) R2 输入9~30V，输出0~5V（幅值可调） Input 9~30V, output 0～5V (adjustable signal range) R3 输入15~30V，输出0~10V（幅值可调） Input 15~30V, output 0～10V (adjustable signal range) R4 输入15~30V，输出4~20mA（幅值可调） Input 15~30V, output 4~20mA (adjustable signal range) 0000 特殊编号:用于特殊的客户需求 Special 4-digit part number: For customized products 无 / None 1米线缆无接插件（标准）/ With 1m cable without connector (standard) J 接插件引出 / With connector 无 / None 无开关 / Without switch A 踩踏初始位置3°左右触发开关信号 Step on the initial position about 3° to trigger the switch signal C 踩踏末端位置3°左右触发开关信号 Step on the end position about 3° to trigger the switch signal 一般性能 / General Specifications 操

Open the catalog to page 1

PHS5 系列脚踏板 PHS5 Series Pedal 电气性能（霍尔电位器） / Electrical Specifications (Hall Effect Potentiometer) 电气性能 Electrical Specifications 工作电压 Applied voltage 工作电流(无负载) Current consumption (no-load) 始末端输出偏差 Output deviation at both ends 输出信号 Output Signal 负载电阻 Load resistance 独立线性公差 Independent linearity tolerance 更新速度 Update rate 绝缘电阻 Insulation resistance 介质耐压 Dielectric strength 电气性能（开关）/ Electrical Specifications (Switch) 2A/30V.D.C., 0.5A/125V.A.C. 电气寿命 Electrical life expectancy 机械寿命 Mechanical life expectancy 接线说明 / Terminal Connection Instructions 端口 Port 常用输出信号图 / Output Characteristics 输出信号 Output...

Open the catalog to page 2

PHS5

PHS5

Catalog excerpts

All SENTOP by Shanghai Sibo M&E Co., Ltd. catalogs and technical brochures