DUAL -WHEELS PRESENTATION
7Pages

DUAL-WHEELS PRESENTATION Capnut about 50 mm Footbase for adjusting angle ATTENTION Socket (Do not lenghten the wrench) wrench Spacer ring HDTS • Maximum speed : 10km/h • Decrease the tyre pression (about half of tyre pressure when mounted without dual-wheels) • Check the proper clamping after 2 hours of use 1 Rue Pascal – ZA Sud – F14700 Falaise – T : +33 2 31 40 80 50 – F : +33 2 31 40 81 80 – E.mail : info

1- Preparation of the tractor rim to fix the capnuts Case n°2 : Welded disc rim with angled portion Case n° 1 : Adjustable track wheel 70 mm maximum from the rim bottom 70 mm maximum from the rim bottom Capnut Capnut Cas n°3 : Welded disc rim, with straight portion Equalizing discs MD/HD (see appendix - p6) 70 mm maximum from the rim bottom Capnut

2- Greasing tractor rim Before mounting the dual-wheel system, APPLY GREASE liberally around the tractor rim Tractor to be put onto bases 3 Rue Pascal – ZA Sud – F14700 Falaise – T : +33 2 31 40 80 50 – F : +33 2 31 40 81 80 – E.mail : info@sodijan

4- Proper clamping Cut the overlength of the headspindles at 3 cm behing the clamp. Make sure that the headspindle does not touch the upper part of the clamp. Make sure that the headspindle does not touch the lower part of the clamp.

Appendix – Equilizing discs Templates to cut and put on the pressed disc to choose the proper angle Templates of equilizing discs for capnuts needed for welded pressed disc rim with angled portion.

5- Extraction of stuck dual-wheels Place the rim so that the extraction hole is located on top. Insert the socket wrench (square side) to extract the dual-wheels from the tractor rim.