NETTING INSTALLATION INSTRUCTIONS
4Pages

For more information visit www.strainrite.co.nz Installation videos available at www.strainrite.co.nz NETTING INSTALLATION INSTRUCTIONS Site preparation Prepare a fence line by flattening or mowing all vegetation or weeds. Further maintenance will be required. (Vegetation that grows up to the first hot wire has a high potential to short out.) Untying and unrolling the net Untie the two tie strings and pull apart the two metal clips to release the roll of net. Grip all the posts as a group and lift them in front of you. This allows the netting to unroll in front of you in a series. Inserting the beginning post Lay unrolled netting on the ground. Locate the beginning post. It’s the post with two tie strings attached and a stainless steel connector at the top. Insert the beginning post into the soil beside a stronger support post or an existing fence. Use the two tie strings to secure the first post to the support post or fence. Keep the net end post(s) at least 5cm away from anything that is conductive (metal, wood, concrete)

For more information visit www.strainrite.co.nz Unfolding the net Grip all remaining posts as a group and lift them up in front of you. Then walk backwards along the intended fence line, “feeding out” each post as it’s pulled from your hands, thereby unfolding the netting. To reduce the risk of tangling the netting, try to drop or toss each post in sequence, helping to free it from the other posts you are still holding. Unfold entire roll of netting along the fence line. Installing posts. Joining 2 rolls of standard netting Starting at the first post, walk along the fence line, picking up...

For more information visit www.strainrite.co.nz Electrifying the Fencing For either solar & battery or mains energizers, attach the lead wire from the fence terminal of energizer to the top clip at the beginning of the net. Attach ground wire from the ground terminal of energizer to earth stake. You can view the full energizer range and accessories at www.strainrite.co.nz Energizer Options The Agri Energizers below a suitable to cover 2 x 50m nets Agri 5 Mains or Battery Agri 5 Solar (Internal battery) Fault Finder (Optional) Strainrite Netting Range Strainrite Poultry Netting 50m...

For more information visit www.strainrite.co.nz Netting Repair Kit Contains: • Polywire • Brass ferrules • Replacement caps for the top of net posts • Replacement caps for the bottom of net posts Instructions: If a horizontal wire has broken, disconnect the power. • • • Cut out the failed section of the horizontal wire. Prepare a replacement length of either conductive or non-conductive material. Tie the replacement material to one side of the break with a knot. If possible, wire join the metal filaments together with a twist to create an electrical connection before the knot is tied....