A100 EH QUICK REFERENCE GUIDE
4Pages

A100 EH QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information Red pipe > Supply (25-35lpm) Blue pipe > Return (Free flow return!!) A. Connect 12V supply to 3pin plug B. Connect wrapper harness to controller ENTERING THE WORKING POSITION 1. Remove the transport pin from the load arm. 2. Adjust the load arm width to suit the correct bale size. 2 3. Adjust the position of the dispenser to ensure that the film will be applied to the centre of the bale. 4. Add the film roll into the dispenser, ensuring that it is threaded correctly, and attach the film to the Cut & Start.

OPERATION Auto mode (A) Auto load + Auto wrap + Auto offload 1. Lower the load arm and drive into the bale until the Auto load paddle contacts the bale. The bale will then be loaded, wrapped, and unloaded Automatically. Auto mode (A) Auto wrap + Auto offload 1. Drive into the bale. Press and release the “Load arm up” button on the controller (a) to load the bale. The bale will be wrapped and offloaded Automatically. Auto mode (A) Auto offload 1. Drive into the bale. Press and release the “Load arm up” button on the controller (a) to load the bale. Press “Auto start” on the controller (b) to...

ENTERING THE TRANSPORT POSITION 1. Rotate the table into the loading position. 2. Raise the load arm fully. 3. Insert the transport pin into the load arm. This will prevent the load arm from lowing when driving on the road. The transport pin should also be used when the machine is being parked. This is a guideline only! Misshapen bales may require more wraps to achieve full coverage. Model Bale Diameter 4 layres 6 layres 16 wraps 24 wraps 32 wraps 20 wraps 30 wraps 40 wraps Extra wrap can be applied during wrapping by pressing the “+1” button. The “No. of Wraps” will return to the set value...

EXPERT CONTROLLER OPERATION 4-way Menu switch: • Set No. of wraps • Change/reset bale sub-total • Access Operator Setup Menu • Access Technician Setup Menu Display in normal working mode: Current No. of Wraps Target No. of Wraps Wrapping speed Bale Total ( 10 seperate stores ) Mode: M ( Manual ) / A ( Auto ) R1 – Table - tip up in Manual mode Autotip in Automatic mode L1 – Table - tip down (in Manual mode) R2 – Release Film Grip R3 – Fast Wrap / Resume Wrap (after stopping mid-cycle using the STOP-switch) R4 – Add 1 wrap to current (or next) bale (only in automatic mode) L4 – Reverse Table...