A200 EH QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information Red pipe > Supply (25-35lpm) Blue pipe > Return (Free flow return!!) Connect 12V supply to 3pin plug Connect wrapper harness to controller Connect receiver to controller The controller can then be mounted in the tractor cab. ENTERING THE WORKING MODE 1. Adjust the position of the dispenser to ensure that the film will be applied to the centre of the bale. 2. Install the bale matt. 2 3. Add the film roll into the dispenser, ensuring that the film is threaded correctly, and attach the film to the Cut & Start.

EXPERT CONTROLLER OPERATION 4-way Menu switch: Set No. of wraps Change/reset bale sub-total Access Operator Setup Menu Access Technician Setup Menu Display in normal working mode: Current No. of Wraps Target No. of Wraps Wrapping speed Bale Total ( 10 seperate stores ) Mode: M ( Manual ) / A ( Auto ) L1 – Table - tip down (in Manual mode) R1 – Table - tip up in Manual mode Autotip in Automatic mode R2 – Release Film Grip R3 – Fast Wrap / Resume Wrap (after stopping mid-cycle using the STOP-switch) R4 – Add 1 wrap to current (or next) bale (only in automatic mode) L4 – Reverse Table L5 – Not used...

Syncing RF Remote with controller receiver If a new remote-control kit is being fitted, or if the battery has been replaced in the remote, the controller must be set to receive the unique frequency of the sender unit: • Ensure ‘RF’ (Radio Frequency) is selected when using the Remote control. Navigate to ‘Operator Setup’ in the RDS controller, and then select RF learn. Press the STOP button on the remote sender. A number will flash on the screen to indicate the controller has received and registered the frequency. If there is an issue with some functions not working correctly on the Remote, by...