S100 A QUICK REFERENCE GUIDE
4Pages

S100 A QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information Red pipe > Supply (35-40lpm) Blue pipe > Return (Free flow return!!) A. Connect 12V supply to 3pin plug B. Connect wrapper harness to controller ENTERING THE WORKING POSITION 1. Remove the wrap arm transport lock. 2. Position the safety arms into the working position by removing the retaining pin. 3. Adjust the load arm stop pin to allow 2 clearance between the top of the bale at the rotating arm. 4. Install the roll of film and attach the film to the Cut & Start.

Activate the “Rollers out” (a) function to open the rollers Drive into the bale until the bale contacts the bale support roller. Activate “Rollers in” (b) to load the bale. Once the bale is loaded, pressing “Auto start” (c) will commence wrapping. When wrapping is complete, press “Rollers out” (a) to offload the bale. Note: “Rollers in” & “Rollers out” functions can be operated by “one touch” meaning that the operator does not need to keep the button pressed. To activate “one touch” increase “Rollers in” & “Roller out” time in the Operator Menu. Using the End Tip 1. The End Tip must first...

EXPERT CONTROLLER OPERATION - Set No. of wraps Change / reset bale sub-total Access Operator Menu Access Technician Menu Current No. of wraps Target No. of wraps Wrapping speed (RPM) Bale total Grand total No. of bales Mode: Manual /Auto Pause wrapping Close cutter Open cutter Fast wrap arm rotate / Resume wrapping Slow wrap arm rotate Pause bale rotation (during wrapping) Reverse wrap arm Rollers out Power on/off / Emergency Stop Start Auto wrap cycle Select Manual or Auto OPTIONAL RF REMOTE OPERATION The RF (Radio Frequency) remote is required if you wish to operate the S100A wrapper...

OPTIONAL HANDHELD REMOTE The operator can activate the main wrapper functions through the handheld remote. This means that the operator can hold the remote in their hand while operating the tractor. Auto mode Rollers out Auto mode Rollers in Auto mode Auto start wrap ENTERING THE TRANSPORT POSITION 3 1. Fully close the loading rollers. 2. Rotate the wrap arm until it is behind the Cut & Start. 3. Insert the wrap arm transport lock. 4. Lock the safety arm into the transport position.