S200V / S300V QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information Red pipe > Supply (35-40lpm) Blue pipe > Return (Free flow return!!) A. Connect 12V supply to 3pin plug B. Connect wrapper harness to controller ENTERING THE WORKING POSITION 1 1. Remove the wrap arm transport lock. 2. Position the safety arms into the working position by removing the retaining pin. 3. Adjust the load arm stop pin to allow clearance between the top of the bale at the rotating arm. 4. Unfold the wrap arms and install the 2/3 rolls of film.

Auto mode (A) Auto load + Auto wrap 1. Drive into the bale until the End Tip roller contacts the bale. The bale will then begin loading automatically. Once loading is complete, the wrapping process will begin automatically. Once wrapping is complete, press the “Rollers out” button to offload the bale. Auto mode can be used with some of the Auto features switched off. These are: Auto load, Auto wrap, Auto unload. This can be done in the Operator Menu. This allows the operator to decide when they would like each step to begin. The below instructions explain how to carry out each Auto step individually....

EXPERT PLUS CONTROLLER OPERATION - Current No. of wraps Target No. of wraps Wrapping speed (RPM) Bale total Grand total No. of bales Mode: Manual / Auto Arm fold (Seq. Reset in Auto) Close cutter Arm unfold (Clear warning) Open cutter (add extra wrap in Auto) Select Auto or Manual Slow wrap Fast wrap / Resume wrapping Menu Reverse wrap arm Rolls rotate (Pause bale rotation in Auto) Power on/off / Emergency Stop Auto start wrap cycle Pause wrapping in Auto OPTIONAL RF REMOTE OPERATION The RF (Radio Frequency) remote is required if you wish to operate the S200V / S300V statically. RF Receiver Load...

OPTIONAL HANDHELD REMOTE The operator can activate the main wrapper functions through the handheld remote. This means that the operator can hold the remote in their hand while operating the tractor. Manual Slow rotate forward Auto mode Auto start wrap Manual Reverse rotate Auto mode Auto start wrap ENTERING THE TRANSPORT POSITION 1. Fully close the loading rollers. 2. Ensure the wrap arms are in the folded position. 3. Rotate the folded wrap arms until they are behind the Cut & Start. 4. Insert the wrap arm transport lock. 5. Lock the outer safety arm into the transport position.