OVERHEATING PROBEREPLACEMENT
8Pages

OVERHEATING PROBE REPLACEMENT

7 black clamps Screw-drivers Probe with red connector (spare part) www.tecoonline.com | www.tecous.com

Disconnect the chiller form power supply. Using the screw-driver, remove the screws indicated in the picture here below (n°16 screws).

Disconnect ground wire from the cover Remove the cover

Disconnect the RED probe connector from main board. Cut the black clamps inside the chiller that embrace the probe’s wire.

Proceed to cut all black clamps that embrace the probe’s wire. Extract the wire from circular passage.

- Cut the last black clamp that embrace the probe’s wire and copper pipe near condenser - Extract the probe and replace it

- Insert probe cable in circular passage - Connect new probe connector to main board - Take new seven black plastic clamps and pinch the probe’s cable with the other cables as it was at the beginning. - Place the chiller cover in its position and then place the sixteen screws to close the chiller. ATTENTION: remember to connect ground wire to the cover before closing the chiller.