Product Segments • Comfort Motion TiMOTION’s TA26 series electric linear actuator is designed for furniture applications such as recliners or lift chairs. This linear actuator is designed to function as a direct cut system, eliminating the need for a control box, offering a straightforward and cost effective alternative to complex electric actuation systems. General Features Max. load Retracted length Output signals Hall sensor(s) Operational temperature range

Standard Dimensions Retracted length Load and Speed CODE Self Locking Force (N) Pull Motor Speed (3800RPM, duty cycle 10%) A Note 1 Please refer to the approved drawing for the final authentic value. 2 T his self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 3 Operational temperature range at full performance: +5°C~+45°C 4 The current & speed in table are tested with 24V DC motor. With a 12V DC motor, the current is approximately twice the current measured in 24V DC; speed will be similar...

Motor Speed (3800RPM) Speed vs. Load 30.0 Performance Data (24V DC Motor)

Rear Attachment (mm) See page 5 1 = Plastic, clevis U, slot 6.2, depth 16.0, hole 10.2 Front Attachment (mm) See page 5 1 = Plastic, no slot, hole 8.2 2 = Plastic, no slot, hole 10.2 3 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole 8.2 Special Functions for Spindle SubAssembly Functions for Limit Switches See page 6 1 = Two switches at full retracted / extended positions to cut current 2 = Two switches at full retracted / extended positions to cut current + 3rd LS to send signal 3 = Two switches at full retracted / extended positions to send signal 4 = Two switches at full retracted...

TA26 Ordering Key Appendix Retracted Length (mm) 1. Calculate A+B = Y 2. Retracted length needs to ≥ Stroke + Y A. Front Attach. 1, 2 Note 1 For stroke over 200mm, +5mm for each increment of 50mm stroke . Rear Attachment (mm) 1 = Plastic, clevis U, slot 6.2, depth 16.0, hole 10.2 Front Attachment (mm) 4 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole 10.2 ø10.2 3 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole 8.2 2 = Plastic, no slot, hole 10.2 1 = Plastic, no slot, hole 8.

TA26 Ordering Key Appendix Functions for Limit Switches Wire Definitions Pin extend (VDC+) retract (VDC+) extend (VDC+) retract (VDC+) extend (VDC+) upper limit switch retract (VDC+) lower limit switch extend (VDC+) upper limit switch medium limit switch retract (VDC+) lower limit switch K = 1 motor direct cut system J = 1 motor direct cut system, with anti-pull cover L = 1+1, 2 motors direct cut system motor 2 S = 1+1, 2 motors direct cut system, with anti-pull cover motor 2 P = Molex 8P, 90° plug, without anti-clip Terms of Use The user is responsible for determining the suitability of TiMOTION...