Unirain F30 - F30F Full Circle Impact Sprinkler Low and Medium flow Brass Application Recommended for agricultural use, and medium fows, and fit largely for removable pipe systems. It can be equipped with one or two nozzles. For the farmer, it is ideal as it is a strong and a long wear life product which reduces evaporation loss and wind effect thanks to its water jet throw radius. It can be assembled with female base thread in order to avoid waste of material. - Made of brass, its arm and body share a wide impact area that grants a longer wear life. - Its counterweighted arm provide a steady turn speed. - It can be assembled with one or two nozzles. - Three different vanes can be used to achieve the desired coverage and pulverisation balance according to the available system pressure. Full circle impact sprinkler 3A" base thread male or female( F30F) Main and secondary nozzle 25° nozzle trajectory angle. Pressure range: 20-80 PSI Nozzle range: 9/64"-7/32" Body, arm and bearing assembly made of brass. Fulcrum pin and springs made of stainless steel. Color-coded anti abrasive acetalic resin nozzles carved in millimetres and inches for a better identification (brass nozzles to be optionally assembled). Backturn lock between the sprinkler body and the bearing spring. Data obtained under ideal test conditions. It can be affected by wind, bad hydraulic conditions or other adverse factors. Highest point of the jet above the nozzle: 2.8 m (using standard nozzle 5 / 32 "to 35.2 MCA) Throw radius jets achieved with the 0.9m lift. Shaded areas not recommended. (*) Standard Nozzle. PSI: Pounds per Square Inch GPM: Gallons Per Minute R(ft): Throw Radius in feet WARRANTY AND EXCLUSIONS The manufacturer guarantees its products for direct customer against any defects in materials or manufacture for a period of two years from the original date of purchase, when the products have been used under normal operating conditions. The manufacturer assumes no responsibi-l ity for installation, removal or repairs carried out by unauthorised personnel. The manufacturer's liability under this warranty is limited to the replacement or repair of defective parts and the manufacturer does not accept responsibility for damages to crops or any other consequential damages deriving from defects in the products covered by this warranty. THE PRESENT WARRANTY SUPERCEDES AND VOIDS ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSES OR ANY OTHER ATTRIBUTING LIABILITY TO THE MANUFACTURER. No agent, employee or representative of the manufacturer is authorised to void, alter or add to the conditions contained in this warranty, nor to take responsibility for, nor to make guarantees not specified herein.