Unirain F40 - F40F Full Circle Impact Sprinkler Low and Medium flow Brass Application Ideal for agricultural use, medium fows, and for removable pipe systems. It can be equipped with one or two nozzles. Sturdy design grants resistance and a longer wear life. Its angle water jet assures perfectly balanced performance of the sprinkler reducing evaporation losses and wind effect. It can be assembled with female base thread in order to avoid waste of material. - Made of brass, its arm and body share a wide impact area that grants a longer wear life. - Its counterweighted arm will provide a steady turn speed. - It can be assembled with one or two nozzles. - Three different vanes can be used to achieve the desired coverage and pulverisation balance according to the available system pressure. - Full circle impact sprinkler - %" base thread male or female( F30F) - Main and secondary nozzle - 25° nozzle trajectory angle. - Body, arm and bearing assembly made of brass. - Fulcrum pin and springs made of stainless steel. - Color-coded anti abrasive acetalic resin nozzles carved in millimetres and inches for a better identification (brass nozzles to be optionally assembled) - Backturn lock between the sprinkler body and the bearing spring. Data obtained under ideal test conditions. It can be affected by wind, bad hydraulic conditions or other adverse factors. Highest point of the jet above the nozzle: 2.8 m (using standard nozzle 5 / 32 "to 35.2 MCA) Throw radius jets achieved with the 0.9m lift. Shaded areas not recommended. (*) Standard Nozzle. PSI: Pounds per Square Inch GPM: Gallons Per Minute R(ft): Throw Radius in feet WARRANTY AND EXCLUSIONS The manufacturer guarantees its products for direct customer against any defects in materials or manufacture for a period of two years from the original date of purchase, when the products have been used under normal operating conditions. The manufacturer assumes no responsibi-l ity for installation, removal or repairs carried out by unauthorised personnel. The manufacturer's liability under this warranty is limited to the replacement or repair of defective parts and the manufacturer does not accept responsibility for damages to crops or any other consequential damages deriving from defects in the products covered by this warranty. THE PRESENT WARRANTY SUPERCEDES AND VOIDS ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSES OR ANY OTHER ATTRIBUTING LIABILITY TO THE MANUFACTURER. No agent, employee or representative of the manufacturer is authorised to void, alter or add to the conditions contained in t