Data obtained under ideal test conditions. It can be affected by wind, bad hydraulic conditions or other adverse factors. Highest point of the jet above the nozzle: 2.8 m (using standard nozzle 5 / 32 "to 35.2 MCA) Throw radius jets achieved with the 0.9m lift. Shaded areas not recommended. (*) Standard Nozzle. Unirain P35 Part Circle Impact Sprinkler Low and Medium Flow Brass Application Ideal for medium flows. It has a sand-proof bearing system and can be equipped with one or two nozzles. High resistance and durability, its reversing system allows that it can be changed in seconds in a full circle sprinkler. Ideal for borderline that should not be wet. - Made of brass, its arm and body share a wide impact area that grants a longer wear life. - Its counterweighted arm will provide a steady turn speed. - Sand proof bearing system. It can be easily disassembled for cleaning or maintenance when needed. - It can be assembled with one or two nozzles. - This model allows using three different vanes to achieve the desired coverage and pulverisation balance according to the available system pressure. - Double use impact sprinkler: 30° to 300a part circle, or full circle. - %" base thread male. - Main and secondary nozzle - 25° nozzle trajectory angle. - Body, arm and bearing assembly made of brass. - Fulcrum pin and springs made of stainless steel. - Color-coded anti abrasive acetalic resin nozzles carved in millimetres and inches for a better identification (brass nozzles to be optionally assembled) - Backturn lock between the sprinkler body and the bearing spring. PSI: Pounds per Square Inch GPM: Gallons Per Minute R(ft): Throw Radius in feet WARRANTY AND EXCLUSIONS The manufacturer guarantees its products for direct customer against any defects in materials or manufacture for a period of two years from the original date of purchase, when the products have been used under normal operating conditions. The manufacturer assumes no responsibi-l ity for installation, removal or repairs carried out by unauthorised personnel. The manufacturer’s liability under this warranty is limited to the replacement or repair of defective parts and the manufacturer does not accept responsibility for damages to crops or any other consequential damages deriving from defects in the products covered by this warranty. THE PRESENT WARRANTY SUPERCEDES AND VOIDS ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSES OR ANY OTHER ATTRIBUTING LIABILITY TO THE MANUFACTURER. No agent, employee or representative of the manufacturer is authorised to void, alter or add to the conditions contained in this warranty, nor to take responsibility for, nor to make guarantees not specified herein.