P45/L Sprinkler Part-circle Plastic 3/4"
1Pages

Unirain P45 - P45L Part Circle Impact Sprinkler Low and Medium Flow Plastic Application Suitable for general agricultural use. Compact in design, it includes a sand-proof bearing system and reinforcing ribs on the sprinkler body. High resistance and durability, and it's made of plastics and treated against the UV radiation. It is a very versatile sprinkler because of its reversing system and pin which allow the sprinkler becoming a full circle one and vice versa. Ideal for borderline areas that should not be wet. Advantages - Sand-proof bearing system and reinforcing ribs on its body. - Perfect inner finish - Its exclusive reversing system is not affected by sand and can be disassembled in seconds without any tools. - It can be assembled with one or two nozzles. Two different model nozzles can be used with the sprinkler: 3Q Bayonet & thread nozzle. - Three different vanes can be used to achieve the desired coverage and pulverisation balance according to the available system pressure. - Double purpose impact sprinkler: part circle ranging from 25° to 325° with 10° steps, or full circle. - %" Male base thread - Main and secondary nozzle - 23° nozzle trajectory angle. - Acetalic resin body and bearing. - Protection cap against UV radiation. - Fulcrum pin and springs made of stainless steel. - Expanded fulcrum,pin upper end diameter for a better fitting into the sprinkler body. - Color-coded anti abrasive acetalic resin nozzles carved in millimetres and inches for a better identification. - Reverse system protected PSI: Pounds per Square Inch GPM: Gallons Per Minute R(ft): Throw Radius in feet Data obtained under ideal test conditions. It can be affected by wind, bad hydraulic conditions or other adverse factors. Highest point of the jet above the nozzle: 2.8 m (using standard nozzle 5 / 32 "to 35.2 MCA) Throw radius jets achieved with the 0.9m lift. Shaded areas not recommended. (*) Standard Nozzle. WARRANTY AND EXCLUSIONS The manufacturer guarantees its products for direct customer against any defects in materials or manufacture for a period of two years from the original date of purchase, only when the products have been used under normal operating conditions. The manufacturer assumes no responsibility for installation, removal or repairs carried out by unauthorised personnel. The manufacturer's liability under this warranty is limited to the replacement or repair of defective parts and the manufacturer does not accept responsibility for damages to crops or any other consequential damages deriving from defects in the products covered by this warranty. THE PRESENT WARRANTY SUPERCEDES AND VOIDS ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSES OR ANY OTHER ATTRIBUTING LIABILITY TO THE MANUFACTURER. No agent, employee or representative of the manufacturer is authorised to void, alter or add to the conditions contained in this warranty, nor to take responsibility for, nor to make guarantees not specified herein.