BEDDINGCART THE FAST & EFFICIENT WAY TO SPREAD BEDDING

BEDDINGCART NEW GENERATION Two models available : 940 / 970, similar to Supercart 542 and 975 – fully welded frame and body for more rigidity to withstand tough conditions. 2 or 4 drive wheels, depending on the model. The unloading auger is located at the rear end of the cart, closer to the driver for easier visual access. Two spring loaded adjusting bolts are used to insure a good tension on the conveyor. A UNIQUE CONFIGURATION The floor goes up at an angle to the discharge auger, which ensures better retention of the material. A heavy #662 pintle chain is used with U-shaped paddles to increase...

Two heavy-duty TMR-type beaters regulate the quantity of material going to the discharge auger. The chopped straw or saw dust can then either drop next to the cart or be spread using the powerful 18’’ (45 cm) impeller. The impeller can spread evenly up to 8’ (2,5m) away from the cart. The bedding cart is equipped with a Honda GX270 13 HP with electric starter. Mounted on the step, the motor’s heat dissipates faster and filling up the tank is easy (guard mounted on a hinge). The impeller is easily positioned in place using a hand- lever. This way, when not needed, it is possible to « hide » the...

HYDRAULIC PUMP / HYDROSTATIC TRANSMISSION Overall Width (propeller in position) 62" (156 cm) Width (retracted propeller) 40" (100 cm) Overall Width (propeller in position) 68" (172,7 cm) Width (retracted propeller) 46" (117 cm) The drive wheels are mounted on wheel motors for less maintenance and more CONTROL VALVE The powerful hydraulic pump provides power to a control valve to operate independently the conveyor, beaters and Specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without prior notice....