twin shaft paddle mixer Process The range of MultiMix paddle mixers, single & twin shaft, premix, and twin shaft coater, is designed to mix a wide range of raw materials, additives and liquids into a homogeneous animal feed mixture within a short mixing time. Benefits and Features High effectiveness ▶ Fast and accurate homogeneity for feed according to GMP+ Guidelines. ▶ Homogeneity: coefficient of variation CV<5% * ▶ Excellent mixing performance and effectiveness because of compact form and high speed mixing ▶ Filling can vary from 30% of nominal filling degree up to 100% ▶ Excellent hygienic properties, because of its round form and complete opening of the mixer outlet ▶ Secure closing of bomb doors due to special lever construction, to prevent product leakage and opening, also in case of pressure loss ▶ Depending on the specific features of the blended ingredients and liquids, liquid addition is possible up to 6% of the total volume ▶ Possibility to spray liquids on the fluidised bed of the mixture, between the two shafts, for hygienic operation ▶ Accurate and customer-specific liquid dosing due to different nozzle executions ▶ Stainless steel liquid spray pipes with pneumatic cleaning function to avoid contamination ▶ Ideal for installation at low construction height ▶ Efficient production process due to short total batch time ▶ Re-adjustable paddle plates for easy maintenance ▶ Exchangeable paddle plates for lower maintenance costs Features ▶ Minimum contamination due to absence of dead corners ▶ Nominal filling at 70% of the total mixer volume for optimal mixing ▶ The paddle plates constructed out of wear resistant stainless steel ▶ Large access door for cleaning purpose ▶ Bomb-door opening in the body is a 60 degree angle ▶ Large bomb doors open up to under the head plates to minimize contamination ▶ Beaters on the bomb-doors for complete emptying to minimize contamination ▶ Steel to steel closure to prevent caking of the product and leakages ▶ Drive by means of shrink disk clamping on shaft mounted gearboxes and V-belt drive ▶ Synchronization mixer-shafts by Cardan shaft ▶ Designed and constructed according to CE and ATEX safety regulations Options ▶ Bomb-door on top for quick filling of mixer ▶ Slides on top for less build-in height ▶ Pipe connection on top for adding additives (manual or with dosing unit) ▶ Product contact parts in stainless steel, except for the paddle shaft ▶ Insulation to prevent condensation for hygienic production ▶ Frequency controlled drive for controlled start-up of the mixer ▶ De-aeration piping for a controlled airflow, from bin below or above mixer, to the mixer ▶ Up to 3 stainless steel liquid spray pipes, mounted on top; more spray pipes possible, on request ▶ The MultiMix paddle mixer can be applied in a weighing configuration, for control-weighing ▶ Possible start-up under full load * recipe and process conditions dependent Datasheet No rights can be claimed, based on the information in this document. Descriptions and illustrations are subject to change, due

Minimum Maximum product product content content* Total mixer volume Motor Main power shafts mixer speed * Kg or liter, whichever comes first, depending on the product density! Maximum product density: 650 kg/m3. Minimum filling *60° bomb door opening Maximum (nominal) filling